Our “2000 Plus Series” systems are an affordable solution
when considering a new switchgear DC supply requirement
or replacement of an aging DC system.

Simultaneous operation of 5 switchgear: This system
can trip and rewind 5 typical switchgear breakers
simultaneously, 140 times during an 8 hour period while
maintaining a constant 3 amp load for the switchgear
indicating lights and relays.

Simultaneous operation of 10 switchgear: This system
can trip and rewind 10 typical switchgear breakers
simultaneously, 58 times during an 8 hour period while
maintaining a constant 3 amp load for the switchgear
indicating lights and relays.

General 120 VDC battery standby system: The system
is also ideally designed to be used as a DC supply for
instrumentation and control, lighting, fire pumps and
extended back up time for UPS; capable of supplying
10.3 amps continuously for 8 hours to an end voltage of
105 VDC at 77o F/25o C. See reverse side for additional
discharge rates
  

• Operating temperature range from 14oF/-10oC
  to 104oF/+40oC. 0 to 95% non-condensing humidity
• Convection cooled cabinet
• Easy installation for handling by forklift
• Knockouts on top and bottom
• Instruction manuals complete with maintenance and
  trouble shooting procedures
• Easy maintenance: total accessibility from the front,
  through a hinged door
• Cabinet: CEMA/NEMA 1,2 mm cold rolled steel
• Audible noise 50 to 65 DBA (measured at 0.9 meter)
• Load terminal blocks in the charger section
• ANSI #61 light grey finish
• 60” H x 27” W x 24” D - 905 lbs
• 1524 mm H x 686 mm W x 610 mm D - 411 kg

• Power Battery’s front access battery
  model SLF-12105
• Valve Regulated Lead Acid (VRLA) design
• 82 AH @ 8 Hr rate
• Absorbent Glass Mat (AGM) technology
• Grids cast of 99.7% pure lead
  calcium tin alloy
• 10 year life expectancy at 25oC (77o F)
• Greater than 99% gas
  recombination efficiency
• No watering required
• Impact resistant frame retardant
  polypropylene cases
• Thermally sealed case to cover bond
• Pressure release safety valves
  (comply with UL924)
• Oversized, low resistance intercell welds
• Cold forged terminal bushings

• Charger output breaker, single or double pole
• Thermostatically controlled cabinet heater
• Load breakers
• Low DC voltage disconnect
• 1% digital meters